D-Link DXS-3600 Series Reference Manual page 212

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in RIPng Global Settings are described below:
Parameter
Global State
Click the Apply button to accept the changes made.
The fields that can be configured in RIPng Settings are described below:
Parameter
Default Metric
Distance
Update Time
Invalid Time
Flush Time
Figure 6-43 RIPng Settings Window
Description
Select to globally enable or disable the RIPng feature here.
Description
Enter the default metric value here. The range is from 1 to 16. This
value is used to specify the default metric for routes redistributed from
other routing protocols. If the routes being redistributed are learned
from other protocols, then they have an incompatible metric as IPv6
RIP. Re-specifying of metric allows the metric to be synced. Select the
Default option to use the default metric value, which is 1.
Enter the administrative distance for RIPng here. The range is from 1
to 254. The distance value represents the trust rating of the route. The
route with a lower distance value is preferred over the route with the
higher distance value. A route with a distance of 255 will not be
installed for the routing of packets since it indicates that the route is not
trusted. Select the Default option to use the default administrative
distance for RIPng, which is 120.
Enter the update interval value at which the update message is sent
here. The range is from 5 to 65535 seconds. Select the Default option
to use the default value here which is 30 seconds.
Enter the invalidate timer value in seconds here. The range is from 1 to
65535 seconds. Select the Default option to use the default value here
which is 180 seconds.
Enter the flush timer value in seconds here. The range is from 1 to
65535 seconds. Select the Default option to use the default value here
which is 120 seconds.
201