Telnet/Web - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Back button to return to the previous window.

Telnet/Web

This window is used to view and configure Telnet and Web settings on the switch.
To view the following window, click Management > Telnet/Web, as shown below:
The fields that can be configured in Telnet Settings are described below:
Parameter
Telnet State
Port
Click the Apply button to accept the changes made.
The fields that can be configured in Source Interface are described below:
Parameter
Source Interface State
Type
VID
Click the Apply button to accept the changes made.
The fields that can be configured in Web Settings are described below:
Parameter
Web State
Port
Click the Apply button to accept the changes made.
Figure 4-21 Telnet/Web Window
Description
Select this option to enable or disable the configuration through Telnet.
Enter the TCP port number used for Telnet management of the Switch.
The "well-known" TCP port for the Telnet protocol is 23.
Description
Select to enable or disable the source interface's state here.
Select the type of source interface that will be used here. Options to
choose from are Loopback, Mgmt, and VLAN.
Enter the interface's ID here. For loopback interfaces the range is from
1 to 8. For the management (Mgmt) interface this value can only be 0.
For VLAN interfaces the range is from 1 to 4094.
Description
Select this option to enable or disable the configuration through the
web.
Enter the TCP port number used for Telnet management of the Switch.
The "well-known" TCP port for the Telnet protocol is 80.
47