D-Link DXS-3600 Series Reference Manual page 257

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
address and the addresses of the candidate RPs from the maps, and gives as an output one RP address
to be used.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4
> PIM BSR Candidate, as shown below:
The fields that can be configured in BSR Candidate Settings are described below:
Parameter
Interface Name
Hash Mask Length
Priority
Interval
Click the Add button to add a new entry based on the information entered.
Click the Delete button to delete an entry based on the information entered.
PIM RP Address
This window is used to view and configure the static multicast groups to RP mapping. In a multicast
domain, the static multicast group to RP mapping can be used together with BSR. All routers in a domain
should have a consistent multicast group to RP mapping. The first hop router that initiates a register
message will use the mapping entries to determine the RP for sending the PIM register message
destined for a specific group. The last hop router that initiates a join message uses the mapping entries to
determine the RP for sending the join and prune message for a specific group. When a router receives a
join message, it will check the mapping entries for forwarding of the message. When a RP receives a
register message, if the router is not the right RP for the multicast group, a register-stop message will be
sent.
Multiple RPs can be defined, each with a single access list.
Figure 6-104 PIM BSR Candidate Window
Description
Enter the name of the interface here.
Enter the hash mask length for RP selection here. The range is from 0
to 32. Select the Default option to use the default value, which is 30.
Enter the Candidate Bootstrap Router's (CBSR) priority value here.
The candidate with the highest priority is preferred. If the priority values
are the same, the router with the highest IP address is preferred. The
range is from 0 to 255. Select the Default option to use the default
value, which is 64.
Enter the interval value between originating bootstrap messages here.
The range is from 1 to 255 seconds. Select the Default option to use
the default value, which is 60 seconds.
246