D-Link DXS-3600 Series Reference Manual page 513

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
VID List
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
IPv6 ND Inspection
This window is used to view and configure the IPv6 ND inspection settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 ND Inspection, as shown below:
The fields that can be configured in IPv6 ND Inspection are described below:
Parameter
Policy Name
Device Role
Validate Source-MAC
Target Port
Unit
From Port ~ To Port
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
Description
Duplicate Address Detection first. ND snooping detects DAD
messages (DAD NS and DAD NA) to build its binding database. The
NDP packet (NS and NA) is also used to detect whether a host is still
reachable and determine whether to delete a binding or not.
Enter the VLAN ID list used here.
Figure 9-55 IPv6 ND Inspection Window
Description
Enter the policy name used here. This name can be up to 32
characters long.
Select the device role here. Options to choose from are Host and
Router. By default, the device's role is set as host and inspection for
NS and NA messages are performed. If the device role is set as router,
the NS and NA inspection is not performed. When performing NS/NA
inspection, the message will be verified against the dynamic binding
table learned from the ND protocol or from the DHCP.
Select to enable or disable the validation of the source MAC address
option here. When the Switch receives an ND message that contains a
link-layer address, the source MAC address is checked against the
link-layer address. The packet will be dropped if the link-layer address
and the MAC addresses are different from each other.
Tick this option to specify the target port.
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
502