D-Link DXS-3600 Series Reference Manual page 380

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Back button to return to the previous window.
Click the Next button to continue.
Protocol Type - PCP
After selecting the PCP option as the Protocol Type, the following section will appear.
Figure 8-17 ACL Configuration Wizard (Create, Packet Type, IPv4, PCP) Window
The fields that can be configured in Assign rule criteria are described below:
Parameter
Source
Destination
IP Precedence
ToS
Description
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host's IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
369