Cpu Protect Counters; Cpu Protect Sub-Interface - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Trap State
The fields that can be configured in CPU Utilization Settings are described below:
Parameter
Rising Threshold
Falling Threshold
Click the Apply button to accept the changes made.

CPU Protect Counters

This window is used to view and clear the CPU protection counter information.
To view the following window, click Security > Safeguard Engine > CPU Protect Counters, as shown
below:
The fields that can be configured in Clear CPU Protect Counters are described below:
Parameter
Sub Interface
Protocol Name
Click the Clear button to clear the information based on the selections made.
Click the Clear All button to clear all the information in this table.

CPU Protect Sub-Interface

This window is used to view and configure the CPU protection sub-interface settings.
To view the following window, click Security > Safeguard Engine > CPU Protect Sub-Interface, as
shown below:
Description
Select to enable or disable the safeguard engine trap state here.
Description
Enter the rising threshold value here. This value must be between 20%
and 100%. This value is used to configure the acceptable level of CPU
utilization before the Safeguard Engine mechanism is enabled. Once
the CPU utilization reaches this percentage level, the Switch will move
into Exhausted mode, based on the parameters provided in this
window.
Enter the falling threshold value here. This value must be between
20% and 100%. This value is used to configure the acceptable level of
CPU utilization as a percentage, where the Switch leaves the
Safeguard Engine state and returns to normal mode.
Figure 9-74 CPU Protect Counters Window
Description
Select the sub-interface option here. Options to choose from are
Manage, Protocol, Route, and All. This option specifies to clear the
CPU protect related counters of sub-interfaces.
Select the protocol name option here.
523