D-Link DXS-3600 Series Reference Manual page 563

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

The fields that can be configured in Ethernet OAM Settings are described below:

From Port ~ To Port

Remote Loopback

Figure 10-20 Ethernet OAM Settings Window

Select the switch's unit ID that will be used here.

Select the switch's port range that will be used here.

Select to enable or disable the Ethernet OAM feature on the specified

port(s) here. After enabling this function on the interface, the interface

will start OAM discovery. If the OAM mode of this interface is active, it

initiates the discovery. Otherwise, it reacts to the discovery received

from the peer.

Select the Ethernet OAM mode here. Options to choose from are

Active and Passive. The following two actions are allowed by ports in

the active mode, but disallowed by ports in the passive mode. (1)

Initiate OAM discovery. (2) Start or stop remote loopback.

Select the remote loopback action here. Options to choose from are

Start and Stop.

Start: Specifies to request the peer to change to the remote

loopback mode.

Stop: Specifies to request the peer to change to the normal

operation mode.

If the remote peer is configured to ignore the remote loopback request,

then the remote peer will not enter or exit the remote loopback mode

upon receiving the request. To start the remote peer to enter the