Super Vlan - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IPv4 Network Prefix / Prefix
Length
IPv6 Network Prefix / Prefix
Length
VID
Priority
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

Super VLAN

This window is used to view and configure the super VLAN settings. Super VLANs are used to aggregate
multiple sub-VLANs (Layer 2 broadcast domains) into IP subnets. A super VLAN cannot have any
physical member port. A super VLAN cannot be a sub-VLAN at the same time. Once an IP interface is
bound to a super VLAN, the proxy ARP will be enabled automatically on the interface for communication
between its sub-VLANs. Multiple super VLANs can be configured and each super VLAN can consist of
multiple sub-VLANs.
Private VLANs and super VLANs are mutually exclusive. A private VLAN cannot be configured as a super
VLAN. Layer 3 routing protocols, VRRP, multicast protocols, and the IPv6 protocol cannot run on a super
VLAN interface.
To view the following window, click L2 Features > VLAN > Super VLAN, as shown below:
Figure 5-27 Subnet VLAN Window
Description
Select and enter the IPv4 address and prefix length value for the
subnet VLAN here.
Select and enter the IPv6 address and prefix length value for the
subnet VLAN here.
Enter the VLAN ID for the subnet VLAN here.
Select the priority value used here. This value is between 0 and 7. A
lower value takes higher priority.
Figure 5-28 Super VLAN Window
110