D-Link DXS-3600 Series Reference Manual page 540

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
KBPS Rise
KBPS Low
Click the Apply button to accept the changes made.
After selecting the Level option as the Level Type, the following parameters are available.
The fields that can be configured in Storm Control Port Settings are described below:
Parameter
Unit
From Port ~ To Port
Type
Action
Level Type
Level Rise
Level Low
Click the Apply button to accept the changes made.
Description
Kbps, and Level.
Enter the rise KBPS value used here. This option specifies the rise
threshold value as a rate of kilobits per second at which traffic is
received on the port. This value must be between 0 and 2147483647
Kbps.
Enter the low KBPS value used here. This option specifies the low
threshold value as a rate of kilobits per second at which traffic is
received on the port. This value must be between 0 and 2147483647
Kbps. If the low KBPS is not specified, the default value is 80% of the
specified risen KBPS.
Figure 9-81 Storm Control (Level Type - Level) Window
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select the type of storm attack that will be controlled here. Options to
choose from are Broadcast, Multicast, and Unicast. When the action
is configured as the shutdown mode, the unicast refers to both known
and unknown unicast packets; that is, if the known and unknown
unicast packets hit the specified threshold, the port will be shutdown.
Otherwise, unicast refers to unknown unicast packets.
Select the action that will be taken here. Options to choose from are
None, Shutdown, and Drop.
•
Selecting None specifies not to filter the storm packets.
•
Selecting Shutdown specifies to shut down the port when the
value specified for rise threshold is reached.
•
Selecting Drop specifies to discards packets that exceed the
risen threshold.
Select the level type option here. Options to choose from are PPS,
Kbps, and Level.
Enter the rise level value used here. This option specifies the rise
threshold value as a percentage of the total bandwidth per port at
which traffic is received on the port. This value must be between 0%
and 100%.
Enter the low level value used here. This option specifies the low
threshold value as a percentage of the total bandwidth per port at
which traffic is received on the port. This value must be between 0%
and 100%. If the low level is not specified, the default value is 80% of
the specified risen level.
529