Ipv6 Route Table - D-Link DXS-3600 Series Reference Manual

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

The fields that can be configured are described below:

IPv6 Address/Prefix Length

Interface VLAN

Next Hop IPv6 Address

Backup State

Click the Apply button to accept the changes made.

IPv6 Route Table

This window is used to view and configure the IPv6 route table.

To view the following window, click L3 Features > IPv6 Route Table, as shown below:

Figure 6-23 IPv6 Static/Default Route Window

Enter the IPv6 address and prefix length for this route here. Tick the

Default Route option to use this route as the default route.

Select the IP Tunnel option to use the IP tunnel feature and enter the

tunnel ID in the space provided. The range of IDs is from 0 to 9999.

Enter the interface's VLAN ID that will be associated with this route

Enter the next hop IPv6 address here.

Enter the administrative distance of the static route here. This value

must be between 1 and 254. A lower value represents a better route. If

not specified, the default administrative distance for a static route is 1.

Select the backup state option here. Options to choose from are

Primary, and Backup. When the Primary option is selected, the route

is specified as the primary route to the destination. When the Backup

option is selected, the route is specified as the backup route to the

destination.

Figure 6-24 IPv6 Route Table Window