Mac Address Table Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Multicast Static FDB
This window is used to view and configure the multicast static FDB settings.
To view the following window, click L2 Features > FDB > Static FDB > Multicast Static FDB, as shown
below:
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
VID
MAC Address
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries.
Click the Delete button to remove the specific entry.

MAC Address Table Settings

This window is used to view and configure the MAC address table's global settings.
To view the following window, click L2 Features > FDB > MAC Address Table Settings, as shown
below:
The fields that can be configured are described below:
Parameter
Aging Time
Figure 5-2 Multicast Static FDB Window
Description
Select the stacking unit ID of the switch that will be configured here.
Select the range of ports that will be used for this configuration here.
Enter the VLAN ID of the VLAN the corresponding MAC address
belongs to.
Enter the static destination MAC address of the multicast packets. This
must be a multicast MAC address. The format of the destination MAC
address is 01-XX-XX-XX-XX-XX.
Figure 5-3 MAC Address Table Settings (Global Settings) Window
Description
Enter the MAC address table's aging time value here. This value must
be between 10 and 1000000 seconds. Entering 0 will disable MAC
address aging. By default, this value is 300 seconds.
92