D-Link DXS-3600 Series Reference Manual page 553

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
MIP Creation
CCM Interval
SenderID TLV
MEPID List
Click the Apply button to accept the changes made.
After clicking the Add MEP button, the following page will appear.
The fields that can be configured in CFM MEP Settings are described below:
Description
This option is used to configure the MIP creation for an MA. Select one
of the following options:
•
None: Specifies not to create the MIP on ports in an MA.
•
Auto: Specifies that MIPs can always be created on any port in
an MA, if that port is not configured with an MEP of this MA. For
an intermediate switch in an MA, the setting must be automatic in
order for the MIPs to be created on this device.
•
Explicit: Specifies that MIPs can be created on ports which has
an existing lower level MEP configured on it, and that port is not
configured with an MEP of this MA.
•
Defer: Specifies to inherit the settings configured for the
maintenance domain that the MA is associated with. This is the
default value.
Select the Continuity Check Message (CCM) interval value here.
Options to choose from are 100ms, 1sec, 10sec, 1min, and 10min.
An MEP will transmit a CCM packet periodically across the MA. The
CCM interval indicates the interval at which CCMs are sent by a MEP
in a MA.
This option is used to configure the transmission of the sender ID TLV
by MPs for an MA. Select one of the following options:
•
None: Specifies not to transmit the sender ID TLV. In the CFM
hardware mode, the value is fixed to none.
•
Chassis: Specifies to transmit the sender ID TLV with the
chassis ID information.
•
Manage: Specifies to transmit the sender ID TLV with the
managed address information.
•
Chassis-Manage: Specifies to transmit the sender ID TLV with
the chassis ID information and the managed address
information.
•
Defer: Specifies to inherit the setting configured for the
maintenance domain that the MA is associated with. This is the
default value.
Enter the Maintenance association End Point's (MEP's) ID contained
in the MA here. The range is from 1 to 8191.
Figure 10-5 CFM Settings (Add MA, Add MEP) Window
542