Lldp-Med Port Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in LLDP Dot3 TLVs Settings are described below:
Parameter
Unit
From Port ~ To Port
MAC/PHY
Configuration/Status
Link Aggregation
Maximum Frame Size
Energy-Efficient Ethernet
Click the Apply button to accept the changes made.

LLDP-MED Port Settings

This window is used to enable or disable transmitting LLDP-MED TLVs.
To view the following window, click L2 Features > LLDP > LLDP-MED Port Settings, as shown below:
Figure 5-77 LLDP Dot3 TLVs Settings Window
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select this option to enable or disable the MAC/PHY
Configuration/Status TLV to send. The MAC/PHY Configuration/Status
TLV is an optional TLV that identifies (1) the duplex and bit-rate
capability of the sending IEEE 802.3 LAN node, and (2) the current
duplex and bit-rate settings of the sending IEEE 802.3 LAN node.
Select this option to enable or disable the Link Aggregation TLV to
send. The Link Aggregation TLV indicates contains the following
information. Whether the link is capable of being aggregated, whether
the link is currently in an aggregation, and the aggregated port channel
ID of the port. If the port is not aggregated, then the ID is 0.
Select this option to enable or disable the Maximum Frame Size TLV
to send. The Maximum Frame Size TLV indicates the maximum frame
size capability of the implemented MAC and PHY.
Select this option to enable or disable the Energy Efficient Ethernet
TLV to send. The Energy Efficient Ethernet TLV indicates the reduce
energy consumption capability of a link when no packets are being
sent.
163