Mld Proxy - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the View All button to display all the entries.

MLD Proxy

MLD Proxy Settings
This window is used to view and configure the MLD proxy settings. The MLD proxy only works in a simple
tree topology. Make sure there are no other multicast routers except for the proxy devices in the simple
tree topology.
When receiving MLD report packet from a downstream interface, MLD proxy will update its membership
database which is generated by the merger of all subscriptions on any downstream interface. If the
database is changed, the proxy device will send unsolicited reports or leaves from upstream interface. It
can also send membership reports from the upstream interface when queried.
To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD Proxy > MLD
Proxy Settings, as shown below:
The fields that can be configured in MLD Proxy Global Settings are described below:
Parameter
Global State
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Proxy Upstream Settings are described below:
Parameter
Interface VLAN
Upstream
Click the Apply button to accept the changes made.
Figure 6-95 MLD Proxy Settings Window
Description
Select to globally enable or disable the MLD proxy feature here.
Description
Enter the VLAN interface's ID here. The range is from 1 to 4094.
Select to enable or disable the interface as the upstream in MLD proxy
here. This feature only takes effect if the interface has an IPv6 address
configured. Only one upstream can exist in an MLD proxy device.
239