Rip Interface Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Click the Distribute Detail button to view more detailed information about the distribute list configuration.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Distribute Detail button, the following page will appear.
Click the Back button to return to the previous window.

RIP Interface Settings

This window is used to view and configure the RIP interface's settings.
To view the following window, click L3 Features > RIP > RIP Interface Settings, as shown below:
The fields that can be configured are described below:
Parameter
VRF Name
Network
Passive Interface
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
Figure 6-40 RIP Distribute List (Distribute Detail) Window
Figure 6-41 RIP Interface Settings Window
Description
Enter the VRF instance's name that will be used here. This name can
be up to 12 characters long.
Enter the IPv4 network address used by RIP here. The interface that
has a subnet defined belonging to a network specified here will be
activated with RIP.
Select to enable or disable the passive interface feature here. This
feature is used to disable the sending and receiving of routing updates
on an interface. However, RIP packet from other routers received on
this interface will continue to be processed.
199