D-Link DXS-3600 Series Reference Manual page 200

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in IP Tunnel Settings are described below:
Parameter
Interface Tunnel ID
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to modify the specified entry.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
The fields that can be configured in IP Tunnel Configure are described below:
Parameter
Status
Description
Tunnel Mode
Source IPv4 Address
Source IPv6 Address
Destination IPv4 Address
Description
Enter the IP tunnel interface's ID here. The range is from 0 to 9999.
Figure 6-30 IP Tunnel Settings (Edit) Window
Description
Select the IP tunnel interface's status here. Options to choose from are
Up and Down.
Enter the description for this IP tunnel interface here. This string can
be up to 64 characters long.
Select the tunnel mode here. Options to choose from are IPv6 IP,
6to4, ISATAP, GRE IP, and GRE IPv6.
•
IPv6 IP: Specifies that the interface is an IPv6 IP tunnel
interface.
•
6to4: Specifies that the interface is a 6to4 tunnel interface.
•
ISATAP: Specifies that the interface is an ISATAP tunnel
interface.
•
GRE IP: Specifies that the interface is a GRE tunnel interface.
The deliver protocol is IPv4 protocol.
•
GRE IPv6: Specifies that the interface is a GRE tunnel interface.
The deliver protocol is IPv6 protocol.
Select and enter the source IPv4 address for the tunnel interface here.
Select and enter the source IPv6 address for the tunnel interface here.
Select and enter the destination IPv4 address for the tunnel interface
here.
189