Vpls Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in Find L2VC Interface Description are described below:
Parameter
L2VC Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
Click the Delete Description button to remove the specified L2VC interface's description.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

VPLS Settings

This window is used to view and configure the Virtual Private LAN Service (VPLS) settings.
To view the following window, click MPLS L2VPN > VPLS Settings, as shown below:
The fields that can be configured in VPLS Settings are described below:
Parameter
VPLS Name
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
The fields that can be configured in VPLS AC Settings are described below:
Parameter
Unit
From Port ~ To Port
SVID
VPLS Name
Description
Enter the L2VC interface's name here. This name can be up to 64
characters long.
Figure 12-5 VPLS Settings Window
Description
Enter the VPLS instance's name here. This name can be up to 32
characters long.
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
Select and enter the SVID here. The range is from 1 to 4094.
Enter the VPLS instance's name here. This name can be up to 32
characters long.
583