Queue Rate Limiting - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Direction
Rate Limit
Click the Apply button to accept the changes made.

Queue Rate Limiting

This window is used to view and configure the queue rate limiting settings.
To view the following window, click QoS > Basic Settings > Queue Rate Limiting, as shown below:
Figure 7-5 Port Rate Limiting Window
Description
Select the switch unit that will be used for this configuration here.
Select the range of ports that will be used for this configuration here.
Select the direction option here. Options to choose from are Input and
Output. When Input is selected, the rate limit for ingress packets is
configured. When Output is selected, the rate limit for egress packets
is configured.
Select and enter the rate limit value here.
•
When Bandwidth is selected, enter the input/output bandwidth
value used in the space provided. This value must be between 8
and 10000000 kbps. Also, enter the Burst Size value in the
space provided. This value must be between 0 and 128000
kilobytes.
•
When Percent is selected, enter the input/output bandwidth
percentage value used in the space provided. This value must be
between 1 and 100 percent (%). Also, enter the Burst Size value
in the space provided. This value must be between 0 and
128000 kilobytes.
•
Select the None option to remove the rate limit on the specified
port(s). The specified limitation cannot exceed the maximum
speed of the specified interface. For the ingress bandwidth
limitation, the ingress will send a pause frame or a flow control
frame when the received traffic exceeds the limitation.
322