Cos To Queue Mapping; Port Rate Limiting - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
WRR Weight
WDRR Quantum
Click the Apply button to accept the changes made.

CoS to Queue Mapping

This window is used to view and configure the CoS-to-Queue mapping settings.
To view the following window, click QoS > Basic Settings > CoS to Queue Mapping, as shown below:
The fields that can be configured are described below:
Parameter
Queue ID
Click the Apply button to accept the changes made.

Port Rate Limiting

This window is used to view and configure the port rate limiting settings.
To view the following window, click QoS > Basic Settings > Port Rate Limiting, as shown below:
Description
Enter the WRR weight value here. This value must be between 0 and
127. To satisfy the behavior requirements of Expedited Forwarding
(EF), the highest queue is always selected by the Per-hop Behavior
(PHB) EF and the schedule mode of this queue should be strict priority
scheduling. So the weight of the last queue should be zero while the
Differentiate Service is supported.
Enter the WDRR quantum value here. This value must be between 0
and 127.
Figure 7-4 CoS to Queue Mapping Window
Description
Select the queue ID that will be mapped to the corresponding CoS
value. Options to choose from are 0 to 7.
321