D-Link DXS-3600 Series Reference Manual page 128

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Src-MAC Address
Dst-MAC Address
Priority
Inner VID
Ethernet Type
Action
New Outer VID
802.1P Priority
New Inner VID
Click the <<Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Add Rule button next to an IP type profile, the following page will appear.
The fields that can be configured in VLAN Mapping Rule are described below:
Parameter
Rule ID
Src-IP Address (IP/Mask)
Dst-IP Address (IP/Mask)
Description
is from 1 to 10000
Enter the source MAC address here.
Enter the destination MAC address here.
Select the 802.1p priority value here. The range is from 0 to 7. A lower
value has a higher priority.
Enter the inner VLAN's ID here. The range is from 1 to 4094.
Enter the Ethernet type value here. The range is from 0x0 to 0xFFFF.
Select the action that will be taken here. Options to choose from are
Dot1q-Tunnel and Translate.
•
Dot1q-Tunnel: Specifies that the outer-VID will be added for
matched packets.
•
Translate: Specifies that the outer-VID will replace the outer-VID
of the matched packets.
Enter the new outer VLAN's ID here. The range is from 1 to 4094.
Select the 802.1p priority value here. The range is from 0 to 7. A lower
value has a higher priority.
After selecting Dot1q-Tunnel as the action, enter the new inner VLAN's
ID here. The range is from 1 to 4094. This option is only available
when Dot1q-Tunnel was selected as the action.
Figure 5-35 VLAN Mapping Profile (IP, Add Rule) Window
Description
Enter the VLAN mapping rule's ID here. If not specified, the rule ID
begins from 10 and is incremented by 10 for every new rule. The range
is from 1 to 10000
Enter the source IPv4 address and subnet mask here.
Enter the destination IPv4 address and subnet mask here.
117