D-Link DXS-3600 Series Reference Manual page 245

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Last Listener Query Interval
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
MLD Group Table
This window is used to find and display the MLD group information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD > MLD Group
Table, as shown below:
The fields that can be configured in MLD Group Table are described below:
Parameter
Interface VLAN
Group
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
MLD SSM Mapping Settings
This window is used to view and configure the MLD SSM mapping settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD > MLD SSM
Mapping Settings, as shown below:
Description
Enter the interval for the amount of time between group-specific or
group-source-specific queries here. When an MLD querier receives a
packet to leave the specific group or channel, it will send a group
specific query or group source specific query. The leave timer starts
once the MLD querier receives the packet from an interface. If the
interface does not receive the report packet before the leave timer
expires, then the interface's membership will be removed from the
group or channel that is to be leaved. The value of the leave timer is
the value of the last-listener-query-interval times the last-listener-
query-count. The range is from 1 to 25 seconds. Select the Default
option to use the default value, which is 1 seconds.
Figure 6-89 MLD Group Table Window
Description
Enter the VLAN interface's ID here. The range is from 1 to 4094.
Enter the group IPv6 address here.
234