Ping Mpls - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
After clicking the Binding FECs Settings tab, the following page will appear.
The fields that can be configured in Binding FECs Settings are described below:
Parameter
IP
Mask
VC
VC ID
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
Click the Delete All button to delete all the entries configured.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Back button to return to the previous window.

Ping MPLS

This window is used to check the connectivity of the LSP for the specified FEC. If there is no LSP for the
specified FEC, the "Destination unreachable" message will be displayed. Otherwise, MPLS echo request
messages will be sent out to along with the LSP of the specified FEC. If the egress LSR received the
request message, it will reply the request message sender with an MPLS echo reply message. If the
sender cannot receive replies before the timeout, the "Request timed out" message will be displayed.
To view the following window, click MPLS > Ping MPLS, as shown below:
Figure 11-18 MPLS QoS Settings (Edit, Binding FECs Settings) Window
Description
Enter the FEC's IP address here. Use this feature to apply an MPLS
QoS policy to FECs. The QoS policy will be applied to all MPLS
packets of the FEC. A FEC can only be bound to at most one policy.
Enter the FEC's subnet mask here.
Enter the FEC's VC address here.
Enter the FEC's VC ID here.
577