11. Mpls; Mpls Ldp Information Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

11. MPLS

MPLS LDP Information Settings

MPLS LSP Trigger Information
MPLS Forwarding Settings
MPLS LDP Neighbor Password Settings
MPLS LDP Neighbor Targeted Settings
MPLS LDP Neighbor Information
MPLS Global Settings
MPLS LDP Interface Settings
MPLS LDP Session Information
MPLS LDP Statistic
MPLS LDP Binding Table
MPLS LDP Discovery Information
MPLS QoS Settings
Ping MPLS
Traceroute MPLS IPv4
MPLS LDP Information Settings
This window is used to view and configure the Multiprotocol Label Switching (MPLS) feature's Label
Distribution Protocol (LDP) information settings.
To view the following window, click MPLS > MPLS LDP Information Settings, as shown below:
The fields that can be configured in MPLS LDP Information Settings are described below:
Parameter
LSR ID
LDP Version
LDP State
TCP Port
UDP Port
Figure 11-1 MPLS LDP Information Settings Window
Description
Enter the Label Switching Router (LSR) ID here. The IPv4 address
must be an IPv4 address of an existing interface. The LSR ID is used
to identify the LSR in the MPLS network. Select the Default option to
use the default setting.
In this field the LDP version will be displayed.
Select to enable or disable the LDP feature here.
In this field the LDP feature's TCP port number will be displayed.
In this field the LDP feature's UDP port number will be displayed.
564