D-Link DXS-3600 Series Reference Manual page 268

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Priority
Click the Add button to add a new entry based on the information entered.
Click the Delete button to delete an entry based on the information entered.
PIM for IPv6 BSR Table
This window is used to view IPv6 PIM BSR information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 BSR Table, as shown below:
PIM for IPv6 RP Address
This window is used to view and configure the IPv6 PIM RP address settings. This feature only affects
PIM-SM operation. Use this feature to statically define the RP address for multicast groups that are to
operate in sparse mode.
Use a single RP for more than one group. The conditions specified by the access list determine for which
groups the RP can be used. Multiple RP can be defined, each with a single access list. The new setting
overrides the old one.
All routers in a domain should have a consistent multicast group to RP mapping. The first hop router that
initiates a register message will use the mapping entries to determine the RP for sending the PIM register
message destined for a specific group. The last hop router that initiates a join message uses the mapping
entries to determine the RP for sending the join and prune message for a specific group. When a router
receives a join message, it will check the mapping entries for forwarding of the message. When a RP
receives a register message, if the router is not the right RP for the multicast group, a register-stop
message will be sent.
If the PIM domain is using embedded-RP, only the RP needs to be statically configured as the RP for the
embedded RP ranges. The other routers will discover the RP address from the IPv6 group address. If
these routers want to select a static RP instead of the embedded RP, the specific embedded RP group
range must be configured in the access list of the static RP.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6
> PIM for IPv6 RP Address, as shown below:
Description
with the same seed hash (correspond) to the same RP. Therefore one
RP can be derived for multiple groups. Select the Default option to use
the default value, which is 126.
Enter the priority value for the BSR candidate here. The range is from
0 to 255. The BSR with the larger priority is preferred. If the priority
values are the same, the router with the larger IPv6 address is the
BSR. Select the Default option to use the default value, which is 64.
Figure 6-119 PIM for IPv6 BSR Table Window
257