D-Link DXS-3600 Series Reference Manual page 221

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
VRF
Click the OK button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
OSPFv2 Interface Settings
This window is used to view and configure the OSPFv2 interface settings.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPFv2 Interface Settings, as
shown below:
The fields that can be configured in OSPF Interface Settings are described below:
Parameter
VRF Name
Area ID
Network IP Address
Network Mask
Click the Apply button to accept the changes made.
Figure 6-56 OSPFv2 Area Settings (Select VRF) Window
Description
Select the VRF instance from the list that will be used here.
Figure 6-57 OSPFv2 Interface Settings Window
Description
Enter the VRF instance's name that will be used here. This name can
be up to 12 characters long. Alternatively, click the Select VRF button
to open a new window to select and use a configured VRF instance
from the list.
Enter the OSPFv2 area's ID here.
Enter the network's IPv4 address here.
Enter the network's IPv4 subnet mask here.
210