Subnet Vlan - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
VLAN Mode
Acceptable Frame
Ingress Checking
Native VLAN
VID
Action
Allowed VLAN Range
Clone
From Port ~ To Port
Click the Apply button to accept the changes made.
Click the Back button to discard the changes made and return to the previous page.

Subnet VLAN

This window is used to view and configure the subnet VLAN settings. A subnet VLAN entry is an IP
subnet-based VLAN classification rule. If an untagged or priority-tagged IP packet is received on a port,
its source IP address will be used to match the subnet VLAN entries. If the source IP is in the subnet of
an entry, the packet will be classified to the VLAN defined for this subnet.
To view the following window, click L2 Features > VLAN > Subnet VLAN, as shown below:
Figure 5-26 VLAN Interface (Trunk Secondary) Window
Description
Select the VLAN mode option here. Options to choose from are
Access, Hybrid, Trunk, 802.1Q-Tunnel, Promiscuous, Host, Trunk
Promiscuous, and Trunk Secondary.
Select the acceptable frame behavior option here. Options to choose
from are Tagged Only, Untagged Only, and Admit All.
After selecting Trunk Secondary as the VLAN Mode the following
parameter will be available. Select to enable or disable the ingress
checking function.
Tick this option to enable the native VLAN function. Also select if this
VLAN supports Untagged or Tagged frames.
After ticking the Native VLAN option the following parameter will be
available. Enter the VLAN ID used for this configuration here. This
value must be between 1 and 4094.
Select the action that will be taken here. Options to choose from are
All, Add, Remove, Except, and Replace.
Enter the allowed VLAN range information here.
Select this option to enable the clone feature.
Select the range of ports that will be used in the clone feature here.
109