D-Link DXS-3600 Series Reference Manual page 261

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
RP Hash
Click the Find button to display a list of access lists based on the selection made.
Click the View All button to display all configured access lists.
PIM Register Settings
This window is used to view and configure the PIM register settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4
> PIM Register Settings, as shown below:
The fields that can be configured in Register Checksum Wholepkt are described below:
Parameter
RP Address Access List
Name
Click the Add button to add a new entry based on the information entered.
Click the Delete button to delete an entry based on the information entered.
The fields that can be configured in Register Probe Time are described below:
Parameter
Register Probe
Click the Apply button to accept the changes made.
The fields that can be configured in Register Suppression Time are described below:
Parameter
Register Suppression
Description
Enter the RP hash address here.
Figure 6-110 PIM Register Settings Window
Description
Enter the standard access list that will be used here. Alternatively, click
the Show List button to find and select any of the exiting access lists
configured on this switch to be used in this configuration.
Description
Enter the register probe time value here. The range is from 1 to 127
seconds. The register probe time is the time before the Register Stop
Timer (RST) expires when a DR may send a Null-Register to the RP to
cause it to resend a Register-Stop message. Select the Default option
to use the default value, which is 5 seconds.
Description
Enter the register suppression timeout value here. The range is from 3
to 65535 seconds. When a DR receives the register stop message, it
250