D-Link DXS-3600 Series Reference Manual page 244

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Interface VLAN
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
Click the Edit button to modify the specified entry.
After clicking the Edit button, the following page will appear.
The fields that can be configured in MLD Interface Settings are described below:
Parameter
Version
MLD State
Query Interval
Query Max Response Time
Robustness Variable
Last Listener Query Count
Description
Enter the associated VLAN ID of the interface here. The range is from
1 to 4094.
Figure 6-88 MLD Interface Settings (Edit) Window
Description
Select the MLD version that will be used on the interface here. Options
to choose from are 1 and 2. Select the Default option to use the
default version, which is MLDv2.
Select to enable or disable the MLD feature on this interface here.
Enter the query interval here. This specifies to configure the frequency
at which the designated router sends MLD general-query messages.
On receiving the general query, the MLD listener needs to respond the
report packet to claim that it is interested in the specified multicast
group. The range is from 1 to 31744 seconds. Select the Default
option to use the default value, which is 125 seconds.
Enter the maximum query response time value here. This specifies to
set the maximum response time, in seconds, advertised in MLD
queries. The range is from 1 to 25 seconds. Select the Default option
to use the default value, which is 10 seconds.
Enter the robustness variable value here. The robustness variable
provides fine-tuning to allow for expected packet loss on an interface.
The range is from 2 to 7. Select the Default option to use the default
value, which is 2.
Enter the last member query count value here. This is used to
configure the number of group-specific or group-source specific
queries sent before the router assumes there are no local members of
a group. If the router does not receive reports from hosts within the
timeout period, the router will stop sending the multicast group traffic to
the interface. The range is from 1 to 7. Select the Default option to use
the default value, which is 2.
233