D-Link DXS-3600 Series Reference Manual page 334

Layer 2/3 managed 10gigabut ethernet switch
Hide thumbs Also See for DXS-3600 Series:
Table of Contents

Advertisement

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Queue ID
Rate Limit
Click the Apply button to accept the changes made.
Figure 7-6 Queue Rate Limiting Window
Description
Select the switch unit that will be used for this configuration here.
Select the range of ports that will be used for this configuration here.
Select the queue ID that will be configured here. Options to choose
from are 0 to 7.
Select and enter the queue rate limit settings here.
When the Min Bandwidth option is selected, enter the minimum
bandwidth rate limit value in the space provided. This value must
be between 8 and 10000000 kbps. Also enter the maximum
bandwidth (Max Bandwidth) rate limit in the space provided.
This value must be between 8 and 10000000 kbps.
When the minimal bandwidth is configured, the packet
transmitted from the queue can be guaranteed. When the
maximum bandwidth is configured, packets transmitted from the
queue cannot exceed the maximum bandwidth even if the
bandwidth is available.
When configuring the minimal bandwidth, the aggregate of the
configured minimum bandwidth must be less than 75 percent of
the interface bandwidth to make sure the configured minimal
bandwidth can be guaranteed. It is not necessary to set the
minimum guaranteed bandwidth for the highest strict priority
queue. This is because the traffic in this queue will be serviced
first if the minimal bandwidth of all queues is satisfied.
The configuration of this command can only be attached to a
physical port but not a port-channel. That is the minimum
guaranteed bandwidth of one CoS cannot be used across
physical ports.
When the Min Percent option is selected, enter the minimum
bandwidth percentage value in the space provided. This value
must be between 1 and 100 percent (%). Also enter the
maximum percentage value (Max Percent) in the space
provided. This value must be between 1 and 100 percent (%).
323

Advertisement

Table of Contents
loading

Table of Contents