D-Link DXS-3600 Series Reference Manual page 70

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Preferred Lifetime
Click the Apply button to accept the changes made.
DHCPv6 Server Local Pool Settings
This window is used to view and configure the DHCPv6 server's local pool settings.
To view the following window, click Management > DHCP > DHCPv6 Server > DHCPv6 Server Local
Pool Settings, as shown below:
The fields that can be configured in DHCPv6 Server Local Pool are described below:
Parameter
Pool Name
IPv6 Address / Prefix Length
Assigned Length
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the User Detail button to view the user information displayed in the lower table.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
DHCPv6 Server Exclude Address
This window is used to specify IPv6 addresses that a DHCPv6 server should not assign to DHCPv6
clients. The DHCPv6 server assumes that all addresses (excluding the switch's IPv6 address) can be
Description
than the preferred lifetime. The range is from 60 to 4294967295
seconds. By default, this value is 2592000 seconds (30 days).
Enter the preferred lifetime value here. The range is from 60 to
4294967295 seconds. By default, this value is 604800 seconds (7
days).
Figure 4-38 DHCPv6 Server Local Pool Settings Window
Description
Enter the DHCPv6 server's pool name here. This name can be up to
32 characters long.
Enter the IPv6 prefix address and prefix length of the local pool here.
Enter the prefix length to be delegated to the user from the pool here.
The value of the assigned length cannot be less than the value of the
prefix length.
59