D-Link DXS-3600 Series Reference Manual page 429

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Specify ICMP Message Type
ICMP Message Type
Message Code
DSCP
Flow Label
Time Range
After selecting the Protocol ID option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-70 Extended IPv6 ACL (Add Rule) Protocol ID Window
The dynamic fields that can be configured are described below:
Parameter
Protocol
Fragments
Source
Description
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IPv6 address here. When the IPv6 option is
selected, the Prefix Length option will also be available. Enter the
destination IPv6 address and prefix length value in the spaces
provided.
Select the ICMP message type used here.
When the ICMP Message Type is not selected, enter the ICMP
Message Type numerical value used here. When the ICMP Message
Type is selected, this numerical value will automatically be entered.
When the ICMP Message Type is not selected, enter the Message
Code numerical value used here. When the ICMP Message Type is
selected, this numerical value will automatically be entered.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the flow label value here. This value must be between 0 and
1048575.
Enter the time profile name that will be associated with this ACL rule,
here.
Description
Enter the Protocol ID value used here. This value must be between 0
and 255.
Select the Fragments option to include packet fragment filtering.
Select and enter the source information here. Options to choose from
are Any, Host, IPv6, and Prefix Length. When the Any option is
418