D-Link DXS-3600 Series Reference Manual page 506

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
ARP Inspection Port Settings
This window is used to view and configure the ARP inspection port settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port ~ To Port
Rate Limit
Burst Interval
Trust State
Click the Apply button to accept the changes made.
Click the Set to Default button to change the information to the default values.
ARP Inspection VLAN
This window is used to view and configure the ARP inspection VLAN settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection VLAN, as shown below:
The fields that can be configured are described below:
Figure 9-45 ARP Inspection Port Settings Window
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Enter the rate limit value here. This value must be between 1 and 150
packets per seconds.
Enter the burst interval value here. This value must be between 1 and
15. Tick the None option to disable the option.
Select to enable or disable the trust state here.
Figure 9-46 ARP Inspection VLAN Window
495