Rip; Rip Settings - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in VRF Loopback Interface Settings are described below:
Parameter
Loopback Interface
VRF Name
Click the Apply button to accept the changes made.
The fields that can be configured in Find VRF Interface are described below:
Parameter
VRF Name
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

RIP

RIP Settings

This window is used to view and configure the Routing Information Protocol (RIP) feature's settings.
To view the following window, click L3 Features > RIP > RIP Settings, as shown below:
The fields that can be configured in RIP Global Settings are described below:
Parameter
RIP State
Click the Apply button to accept the changes made.
The fields that can be configured in VRF Address Family Table are described below:
Description
Enter the loopback interface's ID that will be associated with this VRF
instance here. The range is from 1 to 8.
Enter the VRF instance's name that will be associated with the
specified loopback interface here. This name can be up to 12
characters long.
Description
Enter the VRF instance's name that will be used here. This name can
be up to 12 characters long.
Figure 6-37 RIP Settings Window
Description
Select to globally enable or disable the Routing Information Protocol
(RIP) feature here.
196