Route Preference - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IPv6 Address
IPv6 Address/Prefix Length
Interface VLAN
Connected
RIPng
OSPFv3
ISIS
Database
Hardware
Summary
Click the Find button to locate a specific entry based on the information entered.

Route Preference

This window is used to view and configure the route preference settings. Use this window to configure the
distance representing the trust rating of the route. The route with a lower distance value is preferred over
the route with a higher distance value. A route with the distance 255 will not be installed for routing of
packets since it indicates that the route is not trusted.
To view the following window, click L3 Features > Route Preference, as shown below:
The fields that can be configured in Route Preference are described below:
Parameter
VRF Name
Distance Default
Distance Static
Click the Apply button to accept the changes made.
Description
Select and enter the IPv6 address to display here.
Select and enter the IPv6 address and prefix length to display here.
Select the Longer Prefixes option to display the route and all of the
more specific routes.
Select and enter the interface's VLAN ID to display here.
Select this option to display only connected routes.
Select this option to display only RIPng routes.
Select this option to display only OSPFv3 routes.
Select this option to display only IS-IS routes.
Select this option to display all the related entries in the routing
database instead of just the best route.
Select this option to display only hardware routes. Hardware routes are
routes that have been written into the hardware chip.
Select this option to display a summary and count of the route sources
configured on this switch.
Figure 6-25 Route Preference Window
Description
Enter the VRF instance's name that will be used here. This name can
be up to 12 characters long. Alternatively, click the Please Select
button to open a new window to select and use a configured VRF
instance from the list.
Enter the administrative distance of default routes here. The range is
from 1 to 255. By default, this value is 1.
Enter the administrative distance of static default routes here. The
range is from 1 to 255. By default, this value is 60.
186