D-Link DXS-3600 Series Reference Manual page 511

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured in IP-MAC-Port Binding Trap Settings are described below:
Parameter
Trap State
Click the Apply button to accept the changes made.
The fields that can be configured in IP-MAC-Port Binding Port Settings are described below:
Parameter
Unit
From Port ~ To Port
Mode
Click the Apply button to accept the changes made.
IP-MAC-Port Binding Blocked Entry
This window is used to view and clear the IP-MAC-Port binding blocked entry table.
To view the following window, click Security > IMPB > IPv4 > Advanced Settings > IP-MAC-Port
Binding Blocked Entry, as shown below:
The fields that can be configured are described below:
Parameter
Clear by Port
Unit
From Port ~ To Port
Description
Select the enable or disable the IP-MAC-Port binding option's trap
state.
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select the mode of access control that will be used here. Options to
choose from are Disabled, Strict, and Loose. When a port is enabled
for IMPB strict-mode access control, a host can only access the port
after the host sends ARP or IP packets and the ARP packet or IP
packet sent by the host passes the binding check. To pass the binding
check, the source IP address, source MAC address, VLAN ID, and
arrival port number must match any of the entries defined by either the
IP source guard static binding entry or the DHCP snooping learned
dynamic binding entry. When a port is enabled for IMPB loose-mode
access control, a host will be denied to access the port after the host
sends ARP or IP packets and the ARP packet or IP packet sent by the
host does not pass the binding check. To pass the binding check, the
source IP address, source MAC address, VLAN ID, and arrival port
must match any of the entries defined by either the IP source guard
static binding entry or the DHCP snooping learned dynamic binding
entry.
Figure 9-53 IP-MAC-Port Binding Blocked Entry Window
Description
Select this option to clear the entry table based on the port(s) selected.
Select the switch unit that will be clear here.
Select the appropriate port range that will be cleared here.
500