D-Link DXS-3600 Series Reference Manual page 556

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Alarm Time
Alarm Reset Time
AIS State
AIS Period
AIS Client Level
LCK State
LCK Period
LCK Client Level
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
After clicking the Remote MEP button, the following page will appear.
Figure 10-8 CFM Settings (Add MA, Add MEP, Remote MEP) Window
Click the Back button to return to the previous window.
After clicking the Edit LCK button, the following page will appear.
Figure 10-9 CFM Settings (Add MA, Add MEP, Edit LCK) Window
Description
•
Error-CCM: Specifies that only the fault alarms whose priority is
equal to or higher than "Error CCM Received" will be sent.
•
XCON-CCM: Specifies that only the fault alarms whose priority is
equal to or higher than "Cross-connect CCM Received" will be
sent.
Enter the time period to control when a fault alarm will be sent if a
defect is reported continuously here. The range is from 250 to 1000
centiseconds. By default, this value is 250 centiseconds.
Enter the time period to reset the fault alarm if a defect has not been
reported since the last defect report here. The range is from 250 to
1000 centiseconds. By default, this value is 1000 centiseconds.
Select the enable or disable the AIS feature on this interface here.
Select the transmitting interval of the AIS PDU here. Options to choose
from are 1 Seconds and 1 Minute. The default period is 1 second.
Select the client level ID to which the MEP sends the AIS PDUs here.
The default client MD level is that the most immediate client layer
Maintenance domain Intermediate Points (MIP) and MEPs exist on.
The range is from 0 to 7.
Select the enable or disable the LCK feature on this interface here.
Select the transmitting interval of the LCK PDU here. Options to
choose from are 1 Seconds and 1 Minute. The default period is 1
second.
Select the client level ID to which the MEP sends the LCK PDU here.
The default client MD level is the MD level that the most immediate
client layer MIPs and MEPs exist on. The range is from 0 to 7.
545