D-Link DXS-3600 Series Reference Manual page 119

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

The fields that can be configured are described below:

Acceptable Frame

Ingress Checking

Allowed VLAN Range

From Port ~ To Port

Click the Apply button to accept the changes made.

Click the Back button to discard the changes made and return to the previous page.

When Trunk Secondary was selected as the VLAN Mode, the following page will appear.

Figure 5-25 VLAN Interface (Trunk Promiscuous) Window

Select the VLAN mode option here. Options to choose from are

Access, Hybrid, Trunk, 802.1Q-Tunnel, Promiscuous, Host, Trunk

Promiscuous, and Trunk Secondary.

Select the acceptable frame behavior option here. Options to choose

from are Tagged Only, Untagged Only, and Admit All.

After selecting Trunk Promiscuous as the VLAN Mode the following

parameter will be available. Select to enable or disable the ingress

checking function.

Tick this option to enable the native VLAN function. Also select if this

VLAN supports Untagged or Tagged frames.

After ticking the Native VLAN option the following parameter will be

available. Enter the VLAN ID used for this configuration here. This

value must be between 1 and 4094.

Select the action that will be taken here. Options to choose from are

All, Add, Remove, Except, and Replace.

Enter the allowed VLAN range information here.

Select this option to enable the clone feature.

Select the range of ports that will be used in the clone feature here.