Dhcp Auto Configuration - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
Option
Click the Apply button to accept the changes made.
DHCPv6 Relay Interface Settings
This window is used to view and configure the DHCPv6 relay interface settings.
To view the following window, click Management > DHCP > DHCPv6 Relay > DHCPv6 Relay Interface
Settings, as shown below:
The fields that can be configured in DHCPv6 Relay Interface Settings are described below:
Parameter
Interface VLAN
Destination IPv6 Address
Output Interface VLAN
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

DHCP Auto Configuration

This window is used to view and configure the DHCP auto-configuration function.
To view the following window, click Management > DHCP Auto Configuration, as shown below:
Description
remote ID Option 37 during the relay of DHCP for IPv6 request
packets.
Figure 4-52 DHCPv6 Relay Interface Settings Window
Description
Enter the interface's VLAN ID used in the DHCPv6 relay here. The
range is from 1 to 4094.
Enter the DHCPv6 relay destination address.
Enter the output interface's VLAN ID for the relay destination here. The
range is from 1 to 4094.
Figure 4-53 DHCP Auto Configuration Window
67