D-Link DXS-3600 Series Reference Manual page 202

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
URPF State
Click the Apply button to accept the changes made.
The fields that can be configured in URPF Port Default Settings are described below:
Parameter
Unit
From Port ~ To Port
Reachable Via
Allow Default
IP Access List Name
IPv6 Access List Name
Click the Apply button to accept the changes made.
The fields that can be configured in URPF Port Settings are described below:
Parameter
Unit
From Port ~ To Port
Reachable Via
Allow Default
IP Access List Name
IPv6 Access List Name
Click the Apply button to accept the changes made.
Description
Select to globally enable or disable the URPF feature here.
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
Select the Default option here to specify to verify if the source address
is present in the routing table and the incoming interface matches the
source and is reachable through the interface on which the packet was
received (sometimes referred to as the strict mode).
Select the Default option here to not allow the use of the default route
for URPF verification.
Select the Default option here to specify that no IPv4 access list will
be used in the check.
Select the Default option here to specify that no IPv6 access list will
be used in the check.
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
Select the reachable via option here. Options to choose from are Any
and RX.
•
Any: Specifies to verify if the source address is present in the
routing table (sometimes referred to as the loose mode).
•
RX: Specifies to verify if the source address is present in the
routing table and the incoming interface matches the source and
is reachable through the interface on which the packet was
received (sometimes referred to as the strict mode). This is the
default option.
Select the allow default state here. Options to choose from are True
and False. This feature specifies whether to allow the use of the
default route for URPF verification or not.
Enter the IPv4 access list's name here that will be used for the check.
This name can be up to 32 characters long.
Enter the IPv6 access list's name here that will be used for the check.
This name can be up to 32 characters long.
191