D-Link DXS-3600 Series Reference Manual page 161

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
From Port ~ To Port
Limit Number
Exceed Action
Except ACL Name
VID
Click the Apply button to accept the changes made.
Click the Delete button to delete an entry based on the information entered.
The fields that can be configured in Access Group Settings are described below:
Parameter
Unit
From Port ~ To Port
Action
ACL Name
VID
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Snooping Filter Table are described below:
Parameter
Unit
From Port ~ To Port
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the entries.
Description
Select the appropriate port range used for the configuration here.
Enter the limit number here. This is used to set the limitation on the
number of MLD cache entries that can be created. The range is from 1
to 2048.
Select the exceed action here. This parameter specifies the action for
handling newly learned groups when the limitation is exceeded.
Options to choose from are Default, Drop and Replace.
•
Default: Specifies that the default action will be taken.
•
Drop: Specifies that the new group will be dropped.
•
Replace: Specifies that the new group will replace the oldest
group.
Enter the standard IP access list's name here. The group (*,G), or
channel (S,G) permitted by the access list will be excluded from the
limit. To permit a channel (S,G), specify S in the source address field
and G in the destination address field of the access list entry. To
permit a group (*,G), specify "any" in the source address field and G in
the destination address field of the access list entry. This name can be
up to 32 characters long.
Enter the Layer 2 VLAN's name on a trunk port here. This applies the
filter to packets that arrive on that VLAN. The range is from 1 to 4094.
Description
Select the switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select Add to add a new entry based in the information entered.
Select Delete to delete an entry based in the information entered.
Enter the standard IP access list's name here. This is used to permit
users to join a group (*, G), specify "any" in source address field and G
in destination address field of the access list entry. This name can be
up to 32 characters long.
Enter the VLAN's ID used for this configuration here. The range is from
1 to 4094.
Description
Select the switch's unit ID that will be used here.
Select the switch's port range that will be used here.
150