D-Link DXS-3600 Series Reference Manual page 555

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

Click the Back button to return to the previous window.

After clicking the Edit button, the following page will appear.

Figure 10-7 CFM Settings (Add MA, Add MEP, MEPID Detail, Edit) Window

The fields that can be configured are described below:

PDU Priority

Select to enable or disable the MEP's state on the interface here.

Select to enable or disable the CCM feature's state here.

Select the PDU priority value here. The range is from 0 to 7. This

feature is used to define the 802.1p priority that is set in the CCM and

the LTM messages transmitted by the MEP.

Select the type of fault alarms that will be sent by this MEP. Options to

choose from are None, All, MAC-Status, Remote-CCM, Error-CCM,

and XCON-CCM.

None: Specifies that no fault alarm will be sent.

All: Specifies that all types of fault alarms will be sent.

MAC-Status: Specifies that only the fault alarms whose priority

is equal to or higher than "Some Remote MEP MAC Status

Errors" will be sent.

Remote-CCM: Specifies that only the fault alarms whose priority

is equal to or higher than "Some Remote MEPs Down" will be