D-Link DXS-3600 Series Reference Manual page 428

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
DSCP
Flow Label
Time Range
After selecting the ICMP option as the Protocol Type, the following page and parameters will be
available, as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Description
option, all ports greater than the selected port, will be used. When
selecting the < option, all ports smaller than the selected port, will be
used. When selecting the ≠ option, all ports, excluding the selected
port, will be used. When selecting the Range option, the start port
number and end port number selected, of the range, will be used.
Alternatively, the port number(s) can manually be entered in the
space(s) provided, if the port number(s) is/are not available in the
drop-down list.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the flow label value here. This value must be between 0 and
1048575.
Enter the time profile name that will be associated with this ACL rule,
here.
Figure 8-69 Extended IPv6 ACL (Add Rule) ICMP Window
Description
Select and enter the source information here. Options to choose from
are Any, Host, IPv6, and Prefix Length. When the Any option is
selected, any source traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
source host's IPv6 address here. When the IPv6 option is selected, the
Prefix Length option will also be available. Enter the source IPv6
address and prefix length value in the spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, IPv6, and Prefix Length. When the Any option is
417