Rip; Rip Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured in VRF Interface Settings are described below:
Parameter
Interface VLAN
VRF Name
Click the Apply button to accept the changes made.
The fields that can be configured in VRF Loopback Interface Settings are described below:
Parameter
Loopback Interface
VRF Name
Click the Apply button to accept the changes made.
The fields that can be configured in Find VRF Interface are described below:
Parameter
VRF Name
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

RIP

RIP Settings

This window is used to display and configure Routing Information Protocol (RIP) settings.
To view the following window, click L3 Features > RIP > RIP Settings, as shown below:
Figure 6-38 VRF Interface Settings Window
Description
Enter the ID of the VLAN interface here. The range is from 1 to 4094.
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
Description
Select the ID of the loopback interface here. The range is from 1 to 8.
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
Description
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
241