Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured in LLDP Global Settings are described below:
Parameter
LLDP State
LLDP Forward State
LLDP Trap State
LLDP-MED Trap State
Click the Apply button to accept the changes made.
The fields that can be configured in LLDP-MED Settings are described below:
Parameter
Fast Start Repeat
Count
Click the Apply button to accept the changes made.
The fields that can be configured in LLDP Configurations are described below:
Parameter
Message TX Interval
Message TX Hold Multiplier
ReInit Delay
TX Delay
Click the Apply button to accept the changes made.
LLDP Port Settings
This window is used to display and configure the LLDP port settings.
To view the following window, click L2 Features > LLDP > LLDP Port Settings, as shown below:
Description
Select this option to enable or disable the LLDP feature
Select this option to enable or disable LLDP forward state. When the LLDP
State is disabled and LLDP Forward Sate is enabled, the received LLDPDU
packet will be forwarded.
Select this option to enable or disable the LLDP trap state.
Select this option to enable or disable the LLDP-MED trap state.
Description
Enter the LLDP-MED fast start repeat count value. This value must be between 1
and 10.
Description
Enter the interval between consecutive transmissions of LLDP advertisements
on each physical interface. The range is from 5 to 32768 seconds.
Enter the multiplier on the LLDPDUs transmission interval that used to calculate
the TTL value of an LLDPDU. This value must be between 2 and 10.
Enter the delay value for LLDP initialization on an interface. This value must be
between 1 and 10 seconds.
Enter the delay value for sending successive LLDPDUs on an interface. The
valid values are from 1 to 8192 seconds and should not be greater than one-
fourth of the transmission interval timer.
174
Advertisement
Table of Contents
