Dell S4810 Reference Manual page 93

Hide thumbs Also See for S4810:

Table of Contents

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.2(0.2)

Version 9.1.

Version 8.3.11.1

Version 8.3.1.0

Version 8.2.1.0

Version 7.8.1.0

For the new settings to take effect, save the new CAM settings to the startup-

config (write-mem or copy run start) then reload the system.

The total amount of space allowed is 16 FP Blocks. System flow requires three

blocks and these blocks cannot be reallocated. The ipv4acl profile range is from

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which

is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

If you enabled BMP, to perform a reload on the chassis to upgrade any

configuration changes that have changed the NVRAM content, use the reload

conditional nvram-cfg-change command.

Control and Monitoring

Introduced on the S6000.

Added support for the fcoe parameter on the S4810 and

Added support for OpenFlow on the Z9000.

Introduced on the S4820T.

Added the keywords fcoeacl and iscsioptacl on the

Introduced on the Z9000.

Added the keywords ecfmacl, vman-qos, and vman-dual-

Introduced on the S-Series.

Introduced on the C-Series.