Ip Http Source-Interface - Dell S4810 Reference Manual

ip http source-interface

Specify an interface as the source interface for HTTP connections.
This feature is supported on S4810 platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command CONFIGURATION
Modes
Command
Version 9.3(0.1)
History
Version 8.3.11.1
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Related
ip ftp source interface
Commands
Configuring source interface for ftp communications.
Control and Monitoring
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel followed by a number:
– S-Series: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
a number from 1 to 4094.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the Z9000
Increased number of VLANs on ExaScale to 4094 (was 2094)
Introduced on E-Series ExaScale
Support added for S-Series
Introduced on C-Series
109