Line - Dell S4810 Reference Manual

ftp-server username
connections to the E-Series.

line

Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
S4810
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0
console 0
vty number
end-number
Defaults Not configured
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Control and Monitoring
— sets a username and password for incoming FTP
Enter the keyword aux 0 to configure the auxiliary terminal
connection.
Enter the keyword console 0 to configure the console
port. The console option for the S-Series is <0-0>.
Enter the keyword vty then a number from 0 to 9 to
configure a virtual terminal line for Telnet sessions. The
system supports 10 Telnet sessions.
(OPTIONAL) Enter a number from 1 to 9 as the last virtual
terminal line to configure. You can configure multiple lines at
one time.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
119