Spanning-Tree Bpduforwarding; Stp Show Commands; Show Spanning-Tree - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
5.1.17.1 no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format
Mode

5.1.18 spanning-tree bpduforwarding

Normally a switch will not forward Spanning Tree Protocol (STP) BPDU packets if STP
is disabled. However, if in some network setup, the user wishes to forward BDPU packets
received from other network devices, this command can be used to enable the forwarding.
Default
Format
Mode
5.1.18.1 no spanning-tree bpduforwarding
This command will cause the STP BPDU packets received from the network to be
dropped if STP is disabled.
Format
Mode

5.2 STP Show Commands

This section describes the commands you use to view information about STP
configuration and status.

5.2.1 show spanning-tree

This command displays spanning tree settings for the common and internal spanning tree,
when the optional parameter "brief" is not included in the command. The following details
are displayed.
Format
Modes
5-10
no spanning-tree port mode all
Global Config
disabled
spanning-tree bpduforwarding
Global Config
no spanning-tree bpduforwarding
Global Config
show spanning-tree <brief>
Privileged EXEC
User EXEC
v1.0, November 2007
Spanning Tree Protocol Commands