Ignition Switch Installation - Standard Column; Ignition Switch Installation - Tilt Column - Jeep 1987 Wrangler Workshop Manual

ELECTRICAL
IGNITION SWITCH
IGNITION SWITCH INSTALLATION -
STANDARD COLUMN
With the actuator rod disconnected, position the
ignition switch in place.
M o v e the s l i d e r to the e x t r e m e left
( A C C E S S O R Y position).
NOTE: The left side of the ignition switch is
toward the steering wheel.
Position the actuator rod in the slider hole (1).
Install the switch to the steering column, being
careful not to move the slider out of the detent.
ON
OFF
OFF LOCK
ACC
84999A
STANDARD COLUMN
Hold the key in the A C C E S S O R Y position and
push the switch down the column slightly to
remove slack in the actuator rod.
Tighten the attaching screws securely.
Connect the white connector to the ignition
switch.
Connect the black connector to the ignition
switch.
Install the steering tube cover, if removed.
IGNITION SWITCH INSTALLATION -
TILT COLUMN
With the actuator rod disconnected, position the
switch in place.
M o v e the s l i d e r to the e x t r e m e right
( A C C E S S O R Y position).
NOTE: The right side of the ignition switch is
downward from the steering wheel.
Position the actuator rod (2) in the slider hole.
A C C E S S O R Y
O F F - L O C K
OFF
ON
START
4
TILT COLUMN
C-104