Headlamp Aiming Procedure - Jeep 1987 Wrangler Workshop Manual

ELECTRICAL
EXTERIOR LIGHTING SYSTEM
Attach the four retaining ring screws (B). HEADLAMP AIMING PROCEDURE
Headlamps must be aimed on low beam. They
may be aimed either with mechanical aimers, or,
by using a screen.
Use Headlamp Aimer J-25300-A following the
instructions supplied with the equipment, for
proper aiming.
If a screen is to be used, preparation for aiming
is as follows:
Locate the vehicle in a darkened area with a
level floor and with the screen (wall) having a
nonreflecting white surface.
101354
Mark a reference line on the floor 7.5 meters
(25 ft) away from, and parallel to, the screen.
Attach the four trim ring screws (A).
101353
10